Technical Support
Easy for anyone! Believe it!
We share the technical know-how of Next Float from assembling to dismantling the float and applying technology!
Multi-float assembly method
- Prefabricated floating device capable of unlimited expansion design system with simple assembly
- Depending on the purpose of installation, it can be installed to suit various types of designs and uses
- Applicable to various water projects such as marine water play facilities, marina facilities, and apron
Remember that floats have points 1, 2, 3, and 4 on each edge.
The order of these points determines the assembly order of the float.
Based on point 1 of the float, place the edges of the remaining 3 floats so that the points 2, 3, and 4 meet counterclockwise.
Insert the connecting pin vertically in the place where the 4 connecting hole holes are gathered.
If it is not fully inserted, you can connect the upper part of the joint by applying pressure with a rubber mallet or the sole of the foot.
Insert the dedicated assembly wrench into the two holes at the top of the connecting pin while lying flat. When the assembly key is inserted into the hole, raise the key vertically.
In general, when two people stand opposite each other and strongly rotate the handle 45 degrees to either side, you will feel the connecting pin protrusion caught in the groove of the float.
Then you are fully coupled.
Request for consultation and quotation
For quick consultation, please fill out the information below and apply, and we will reply (within 24 hours on weekdays).
- 1.Consulting
- 2.Send notice
- 3.Assign a contact
- 4.Reply to consultation
NEXT co., Ltd. 16-5, Oncheon-ro 165beon-gil, Paltan-myeon, Hwaseong-si, Gyeonggi-do, Republic of Korea
- Tel +82)31-447-7977
- Fax +82)31-443-7119
- Email nextfloat@next700.com